You hereby state for the Administrator that you are eighteen (18) years old or older (or that you have reached other age which, pursuant to the law of your country, entitles you to enter into legally binding contracts), you have full capacity to enter into legal transactions and that you agree to the terms and conditions set forth herein. You hereby state and represent that you accept all the provisions of the Terms of Use and the Privacy Policy without any reservations.Ģ. Uploaders who are unable to enter into a legal binding agreement with the Administrator or a User, or those who are forbidden to use services provided by the Website due to restrictions applicable in the country or in the region, including the current country of residence of the User and the place where the User is using the services, should not use the Website. Medium – a material or a tool in which the User (or the Uploader, or the Administrator) can store information sent to them by the Administrator or the Uploader in a manner that allows for the future access to information during a period which is appropriate for the purposes for which such information is used, and which allows for the restoration of the stored information in the same form. Privacy Policy - a set of personal data processing and data privacy protection rules applied by the Administrator to Users and Uploaders.Īccount - an account maintained on the Website for the User, with which the User may use the services offered by the Website and use the Website’s full functionality. Model – a file with a model for a Skriware 3D printer. ![]() Uploader – an individual or an entrepreneur who sells or shares for free via the Website Models owned by them. Website - a group of connected web pages, made available on the Internet at User (You, Your) - each person who uses any functionality of the Website and/or has signed in to the website. Wołodyjowskiego 45, 02-724 Warszawa, entered in the Register of Entrepreneurs by the District Court for the Capital City of Warsaw, 13th Commercial Division of the National Court Register under entry No. DefinitionsĪdministrator - Skriware spółka z ograniczoną odpowiedzialnością with its seat in Warsaw, address: ul. This document defines the legal (contractual) relationship between the Uploader and the Administrator, as well as the legal (contractual) relationship between the User and the Uploader. TERMS OF USE OF THE WEBSITE SKRIWARE FOR UPLOADERS The part can be freely modified by following the link below: Feel free to test it yourselves and share your findings with me. Bridging tests resulted in (marginally) less dangling and benchies printed mostly flawlessly for both fan shrouds, but were only slightly more stable on the front overhang with my fan shroud. Overall, my fan shroud did outperform the stock fan shroud in my testing, but not by an earth-shattering amount. That being said, this fan performed better than stock in most of my testing. In my testing, I found the limiting factor is mostly print settings and as long as the fan shroud does its job, the print quality can't be improved beyond what your slicer settings allow. The intention of this was to improve cooling rate on smaller prints. I combined this flow simulation testing with real world testing to determine if it meets my design goal. The goal with this design was to send as much air towards the tip of the nozzle as possible. I learned how to set up flow simulations and used that to help me tune the performance of the fan duct. ![]() However, this fan duct works fairly well. My previous experiment, the 360 degree fan duct, didn't work out as well as I had hoped. I've learned a lot from experimenting with different designs of fan duct.
0 Comments
Leave a Reply. |